P2R Hybrid Bodypack Receiver 

The P2R Hybrid Bodypack Receiver is the world's first bodypack receiver to function as a wired receiver, a wireless receiver, or both at the same time. This and other unique features, along with excellent sound quality, make the P2R an exceptional value.  

RF Sensitivity

-109 dBm typical

Squelch Threshold

-102 dBm typical

Antenna

Attached Whip

Audio Input Connector

Connector Type: 1/4-inch Mono

Impedance: 1 megohm

Maximum Input Level: LO = +0 dBu; HI = ­10 dBu

Frequency Response: 30 Hz to 20 kHz (+/-3 dB); earphone dependent

Power Requirements

9 V alkaline battery, Duracell® type MN1604 recommended

Battery Life

Volume Dependent

Wired (RF Off): 6 hours

Wireless (RF On): 4 hours

Audio Output Connector

1/8 inch (3.5 mm)

Minimum Load Impedance

8 ohms

Net Weight

100 g (3.52 oz.), less battery

Overall Dimensions

122 mm x 73 mm x 32 mm (4.809 in. x 2.875 in. x 1.251 in.)

P2T Wireless TransMixer

The P2T TransMixer is breakthrough design for personal monitoring. It allows the user to connect two line-level or miclevel inputs directly into the transmitter. The two signals can then be mixed independently. You can connect microphones or instruments directly to the inputs or use line outputs from a mixing console. In short, no matter what the output device, you can probably plug it into the TransMixer.  For use with PSM 200 monitors. 

RF Output Power

30 mW (+15 dBm) typical conducted (country dependent)

Modulation Limiter

Internal peak limiter (>10:1 hard knee compression)

Antenna

1/4 Wavelength, semi-rigid, PCB Mount

P2T Audio Input

Connector Type: XLR-1/4-inch combo

Configuration: electronically balanced

Actual Impedance: 1 kilohm

Nominal Input Level: ­25 dBu @ 1/2 volume (12 o'clock)

Maximum Input Level: ­5 dBu @ 1/2 volume (12 o'clock)

Pin Assignments:

XLR: 2=hot; 3=cold, 1=ground

1/4: Tip = hot, Ring = cold, Sleeve=ground

Phantom Power Protection? Yes: Up to 52 Vdc