Descriere

IRIS-Net module for remote control and supervision of DSA Series power amplifiers.
This module provides very cost-effective integration of all 2-, 4- and 8- channel DSA Series power amplifiers into IRIS-Net networks allowing comprehensive remote control and supervision.
Control features are: Configuration, Power ON/OFF, Power On Delay, Mute, Variable Load Drive
Supervision parameters are: Load supervision for each channel, Output VU, Protect, Limit, Pilot tone, Temperature, Gain/Sensitivity.
In addition a GPIO block allows for 2 Control Inputs, 2 Control Outputs, 2 Reference Outputs (+5 V, 200 mA / GND)

Specificatii tehnice

Remote Control and Software IRIS-Net™, Multiple PCs possible, MS Windows 2000, XP, Vista
Maximum Configuration 250 Amplifiers in total, 100 Amplifiers per CAN bus, 1000 meter cable run
Supervised Amplifier Parameters Operation mode, temperature, output voltage and current, impedance of
connected speakers, protection mode status, pilot tone detection
Network Supervision CAN bus failures, defective or missing amplifiers, bandwidth, failure protocol
and messaging
INTERFACES
CAN 10...500 kbaud, 2 x RJ-45 (IRIS-Net™ Control)
GPIO Control Port 2 x 3-pole Euro block
2 Control Inputs
2 Control Outputs
2 Reference Outputs (+5 V, 200 mA / GND)
RCM-810 GENERAL SPECIFICATIONS
Supply Voltage/Current +5 V DC / 320 mA
+15 V DC / 80 mA
-15 V DC / 80 mA
Power Consumption 4 W
Operating Temperatur Range 0 °C...40 °C
Dimensions (W x H x D) 103.5 x 37 x 103 mm
Weight 115 g
ACCESSORIES
3-pole Euro block connector For GPIO Control Port